We are doing a major upgrade to our databases. To facilitate this we need to suspend all CM Jobs for one day.
Is there a good way, without entering each table, to suspend the new day jobs?
CM v6.4
Thank you,
Goo
Suspend All New Day Jobs for 24 Hours
Re: Suspend All New Day Jobs for 24 Hours
Not sure about v. 6.4
we can do the same using workload management by keeping the Running jobs policy to 0
we can do the same using workload management by keeping the Running jobs policy to 0
Re: Suspend All New Day Jobs for 24 Hours
from v8 workload policies
from v9 also PAUSE mode controlM
In v 6.4 (upgrade it) ctmsusped and if have doub test it in a test environment.
You can also if the interval dosent contain NDP: stop all execution manually (hold), wait all is ok and then shut down the ctmserver: when it is started you have all jobs in hold state and can control start.
Regards
from v9 also PAUSE mode controlM
In v 6.4 (upgrade it) ctmsusped and if have doub test it in a test environment.
You can also if the interval dosent contain NDP: stop all execution manually (hold), wait all is ok and then shut down the ctmserver: when it is started you have all jobs in hold state and can control start.
Regards