ControlM agent 6.4 install on W2008 R2 in a cluster mode

bucheron74 · Post by **bucheron74** » 14 Feb 2011 9:45

Hello,
Is someone has tried to install controlM agent 6.4.01.200 on Windows 2008 R2 64 bits in a cluster mode ? If yes what are the different steps to do.

Our conf : 2 nodes : nodeA and NodeB. Each node have a system install and we have a disk which is moving sometimes from nodeA to NodeB.

What we have done is :

installing an agent 6.4.01 on nodeA on C: disk
installing an agent 6.4.01 on node B on C: disk
installing FP 6.4.01.200 on nodeA and nodeB

When we start the agent on nodeA --> agent available from CCM menu
When we switch the agent to nodeB --> agent is unavailable from CCM menu.

I have made some researches and I have seen that people are talking about media 94183 to install but I am not so familiar with EDP and I do not know how to use it.

Help is very welcome.

Thanks for your reply.

Bucheron74.

mauriziog · Post by **mauriziog** » 03 Mar 2011 11:13

Your installation is not in cluster mode.
You must do a cluster installation, see the agent installation guide.

In this kind of installation the disk resourse is one and moves fron nodeA to nodeB, when do so the agent also moves with it.

bucheron74 · Post by **bucheron74** » 03 Mar 2011 11:21

Hello Mauriziog,

Thanks for your reply.

I have found how to install it in a cluster mode using agent downloading from EPD site, then using cluster_group mode.

Best regards.