Setting Trace thru a job

Nancy · Post by **Nancy** » 03 Nov 2009 12:50

Hi,
I am trying to set a job to run these following commands.
TRACE_CTM on
TRACE_CLIENT on
TRACE_LINK_CTM on
em_data_collector.bat

Is it ok if I will create a batch file called CTMDEBUG.bat which will contain all these commands?

If this is the case then where can i mention the DBO credential to execute the em_data_collector.bat?

To run these job is it requred to install an Agent in the EM?

Anysorts of advice would be highly appreciated.

Nancy

philmalmaison · Post by **philmalmaison** » 04 Nov 2009 11:32

are you talking about ctm_data_collector used in EM ?
you can use it as a command line or create a controlm job.
in this case you must have an agent or agentless to submit it

CONTROL-M/Enterprise Manager Utility Guide
page 176 Table 63 Category definitions for the ctm_data_collector utility

regards
philmalmaison

rustycusak · Post by **rustycusak** » 16 Jan 2010 2:12

That was a great post, helped me a lot with the profiler tool. But I can't find the code in "listing 1" and "listing 2", where are these files? regards...

Thanks.