Hi,
I am trying to set a job to run these following commands.
TRACE_CTM on
TRACE_CLIENT on
TRACE_LINK_CTM on
em_data_collector.bat
Is it ok if I will create a batch file called CTMDEBUG.bat which will contain all these commands?
If this is the case then where can i mention the DBO credential to execute the em_data_collector.bat?
To run these job is it requred to install an Agent in the EM?
Anysorts of advice would be highly appreciated.
Nancy
Setting Trace thru a job
- philmalmaison
- Nouveau
- Posts: 1148
- Joined: 08 Jun 2007 12:00
- Location: Ile de France
are you talking about ctm_data_collector used in EM ?
you can use it as a command line or create a controlm job.
in this case you must have an agent or agentless to submit it
CONTROL-M/Enterprise Manager Utility Guide
page 176 Table 63 Category definitions for the ctm_data_collector utility
regards
philmalmaison
you can use it as a command line or create a controlm job.
in this case you must have an agent or agentless to submit it
CONTROL-M/Enterprise Manager Utility Guide
page 176 Table 63 Category definitions for the ctm_data_collector utility
regards
philmalmaison
- rustycusak
- Nouveau
- Posts: 1
- Joined: 11 Jan 2010 12:00