Cyclic Jobs - TARGET option

All questions about Control-M jobs definitions
Post Reply
User avatar
karan
Nouveau
Nouveau
Posts: 20
Joined: 25 May 2011 12:00

Cyclic Jobs - TARGET option

Post by karan » 16 Jul 2014 7:30

Hi

Has anyone used the TARGET option while defining cyclic jobs?
If so, please let me know the feature of it.

User avatar
jCarlos
Nouveau
Nouveau
Posts: 36
Joined: 19 Jun 2013 12:00

Post by jCarlos » 18 Jul 2014 2:32

that's you can do:

General information
The interval between job runs is specified in the Interval parameter.

When the value of Rerun From is Start, the time until the next job run is counted from the moment that the current job run begins.

When the value of Rerun From is End, the time until the next job run is counted from the moment that the current job run is complete.

When the value of Rerun From is Target, the interval is measured from the scheduling time of the current job run.

User avatar
karan
Nouveau
Nouveau
Posts: 20
Joined: 25 May 2011 12:00

Post by karan » 18 Jul 2014 4:20

Hi Carlos

This is actually not working. I have tested it.If you have, then kindly present the elaborated test results.

Post Reply