Page 1 of 1
Cyclic Jobs - TARGET option
Posted: 16 Jul 2014 7:30
by karan
Hi
Has anyone used the TARGET option while defining cyclic jobs?
If so, please let me know the feature of it.
Posted: 18 Jul 2014 2:32
by jCarlos
that's you can do:
General information
The interval between job runs is specified in the Interval parameter.
When the value of Rerun From is Start, the time until the next job run is counted from the moment that the current job run begins.
When the value of Rerun From is End, the time until the next job run is counted from the moment that the current job run is complete.
When the value of Rerun From is Target, the interval is measured from the scheduling time of the current job run.
Posted: 18 Jul 2014 4:20
by karan
Hi Carlos
This is actually not working. I have tested it.If you have, then kindly present the elaborated test results.