About some SNMP configuration
Posted: 09 Feb 2012 4:56
Hi,
I would like to use SNMP for following case.
1.Job Ended NOT OK
2.Control-M send the remote batch to local terminal
3.Local terminal receive the remote batch
4.warning light (like a lamp on the roof of police car) connected to the terminal by USB is turned on to notice the operator that the job abended.
If the system meet this few case, is use SNMP to capture the message and send mail with SMTP? Or have any method? And how can I set the setting at EM server?
Thanks
I would like to use SNMP for following case.
1.Job Ended NOT OK
2.Control-M send the remote batch to local terminal
3.Local terminal receive the remote batch
4.warning light (like a lamp on the roof of police car) connected to the terminal by USB is turned on to notice the operator that the job abended.
If the system meet this few case, is use SNMP to capture the message and send mail with SMTP? Or have any method? And how can I set the setting at EM server?
Thanks