Scheduler Usage

We are doing a major upgrade to our databases. To facilitate this we need to suspend all CM Jobs for one day.

Is there a good way, without entering each table, to suspend the new day jobs?

CM v6.4

Thank you,

Goo

just unset the time in which control-m do the daily refresh.

Thanks Carlos, could you point me to where this is done?

I will look in manuals but a quick guide would be nice as we are looking at noon today.

Thanks again,

Goo

Hi,

You can ask some one from admin team to suspend the control-m server by ctmsuspend utility
in this case jobs will come into AJF but will not run untill the ctmsuspend utility run again to reinstat the normal processing .

THanks,
Chandramani

Thank you, can we still force jobs to run or will all jobs be prevented from running?

Goo

Not sure about v. 6.4

we can do the same using workload management by keeping the Running jobs policy to 0

from v8 workload policies
from v9 also PAUSE mode controlM

In v 6.4 (upgrade it) ctmsusped and if have doub test it in a test environment.
You can also if the interval dosent contain NDP: stop all execution manually (hold), wait all is ok and then shut down the ctmserver: when it is started you have all jobs in hold state and can control start.

Regards