Control-M Database Table CMR_RUNINF
- peterrowan
- Nouveau
- Posts: 22
- Joined: 23 Dec 2008 12:00
Control-M Database Table CMR_RUNINF
This table seems to hold information about every job ever run by control-m. Is there a housekeeping process or utility or parameter to manage this table. I would prefer to keep 6 months of info in this table at most.
Hi,
In the <config.dat> file of the Control-M/Server you have 2 parameters:
RUNINF_PURGE_LIMIT
Number of Run Information records to keep for a given MemName/MemLib/NodeID.
Default: 20.
RUNINF_PURGE_MODE
0 - save the statistics of last x records.
1 - save the statistics of last x days.
Default: 0
Perhaps in the <config.dat> file, these two parameters are missing, in this case the defaults are used.
If you modify this file, the Control-M/Server must be recycle to make the change take effect.
This change will be take effect only the Next New Day.
Don't forget this parameters will have an impact on the Control-M/Server Database (size of the database)
See CONTROL-M/Server Admin guide (configuration parameters)
In the <config.dat> file of the Control-M/Server you have 2 parameters:
RUNINF_PURGE_LIMIT
Number of Run Information records to keep for a given MemName/MemLib/NodeID.
Default: 20.
RUNINF_PURGE_MODE
0 - save the statistics of last x records.
1 - save the statistics of last x days.
Default: 0
Perhaps in the <config.dat> file, these two parameters are missing, in this case the defaults are used.
If you modify this file, the Control-M/Server must be recycle to make the change take effect.
This change will be take effect only the Next New Day.
Don't forget this parameters will have an impact on the Control-M/Server Database (size of the database)
See CONTROL-M/Server Admin guide (configuration parameters)
Best regards
Walty
Walty