It is currently 18 Dec 2017 7:36


Post new topic  Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Cyclic interval change
PostPosted: 30 Oct 2015 8:01 
Offline
Nouveau
Nouveau
User avatar

Joined: 23 Aug 2013 12:00
Posts: 10
Location: Banglore
Hello,

Is there any option to change the cyclic interval change incase of failure or success in Control M Version 7.

For example: We scheduled a job to run every 3 hours. Incase if it fails, it should run every 5 minutes until in completes successfully.


Top
   
PostPosted: 18 Nov 2015 1:53 
Offline
Nouveau
Nouveau
User avatar

Joined: 28 Apr 2015 3:46
Posts: 20
Yes, when notok, do forcejob of another table that has the 5 min cycle, but also has a in cond that gets removed once your runs are ok, the same cond can be a in cond for your first cycle jobs.
By use of the cond, only one set of cyclic jobs will run


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited
The site created by Franck YOT. Images, logo, content and trademarks about Control-M products are property of BMC Software.
All the comments are property of their posters. Images, logo, content and design are © copyright by Scheduler-Usage.com. All Rights Reserved