It is currently 27 May 2017 6:03


Post new topic  Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Set tab
PostPosted: 22 Jan 2012 4:39 
Offline
Nouveau
Nouveau
User avatar

Joined: 25 May 2009 8:00
Posts: 150
Location: Bangalore
Can anyone please explain about set tab in Job Editing form in Control-M/EM GUI.

Thanks in advance !!!


Top
   
 Post subject:
PostPosted: 29 Jan 2012 7:30 
Offline
Nouveau
Nouveau
User avatar

Joined: 21 Oct 2011 8:00
Posts: 13
This is where Auto-Edit variables are defined. Auto-Edit variables are a somewhat complex topic, because there are a lot of them, and they display varied behavior.

A good place to start is the Control-M User Guide. If you want to jump right into Auto-Edit variables, flip to p. 87, which takes you to the following section:

Part 2 - Defining the production environment > 4 Defining how jobs should run > Creating and editing jobs > Defining and using variables that are dynamically resolved at runtime


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+10:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited
The site created by Franck YOT. Images, logo, content and trademarks about Control-M products are property of BMC Software.
All the comments are property of their posters. Images, logo, content and design are © copyright by Scheduler-Usage.com. All Rights Reserved